- If, ,, or was assigned to a control using Custom Setting f2 with selected for in the stored settings, the camera would sometimes fail either to focus or to track the desired subject when autofocus was initiated by pressing the chosen control in focus mode AF-C.

- If an option other than was chosen for with, ,, or selected for, autofocus would sometimes fail when subjects were detected outside the focus point.

Improved focus tracking in focus mode AF-C when, ,, or is selected for.

The MC-N10 remote grip can now be used for synchronized release on cameras connected via a ten-pin remote terminal.

- In extremely rare cases, the camera would stop responding.Ĭhanges from Previous Versions Changes from “C” Firmware Version 3.00 to 3.01.- Rating pictures during playback zoom would in some instances temporarily corrupt the display.- Copies created by blending a large number of pictures together using the > item in the playback “i” menu would sometimes exhibit a green color cast.- The > item in the playback “i” menu would in rare cases create distorted copies or not permit selection of the desired crop.Improved the frame advance rate during burst photography with optional flash units.Improved focus accuracy for low-contrast subjects during burst photography with, ,, ,, or selected for.Added support for NIKKOR Z 85 mm f/1.2 S lenses.Do not turn off the camera until the firmware update is complete.Ĭhanges from “C” Firmware Version 3.01 to 3.10 A progress bar will be displayed when the update begins, but when updating from a “C” firmware version earlier than 2.00 you may notice that it takes about 2 minutes for the progress bar to be displayed. This update takes approximately 6 minutes. Read the information below before proceeding.This update includes all changes made in previous updates.

You will not need to download this update if the firmware listed above is already installed. Use Firmware version in the SETUP MENU to check the camera firmware version before proceeding. This service supplies software that can be used to update the Z 9 camera “C” firmware to version 3.10.Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement. This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below.

Zoom download center mac